• separator with a rotating drum consisting of 24 PVC rollers with a diameter of 50 mm and a length of 800 mm (the distance between the rollers can be adjusted MANUALLY)
• each separator has its own inverter to regulate the drum rotation speed; possible adjustment range: minimum 4 rpm, maximum 20 rpm
• the SR separator has a manual adjustment of the distance between the rollers
• the drum frame is supported by two threaded rods that allow the drum tilt to be adjusted on both sides
• finding the right ratio of the drum rotational speed to the slight counter-inclination allows for effective separation of the product from the sprue
• in standard separators, the roller drum can be replaced with a perforated drum
• motor supply voltage: 220 V / 50 Hz, single-phase

• separator with a perforated rotating drum made of AISI 304 stainless steel sheet, usually with small anti-slip tubes
• each separator has its own inverter to regulate the drum rotation speed; possible adjustment range: minimum 4 rpm, maximum 20 rpm
• in the SM separator, the diameter of the holes and the need to weld anti-slip pipes depend on the shape of the product and the sprue
• the drum frame is supported by two threaded rods that allow the drum tilt to be adjusted on both sides
• finding the right ratio of the drum rotational speed to the slight counter-inclination allows for effective separation of the product from the sprue
• motor supply voltage: 220 V / 50 Hz, single-phase

• separator with independent base on the ground (for positioning in front of the conveyor only when necessary)
• separator chute made of polished AISI 304 stainless steel sheet
• gearbox assembly located on the right side, power 0.09 kW, with torque limiter
• rotational speed of the distribution roller: 70 rpm
• starting and stopping the separator using a Siemens motor switch
• standard motor supply voltage 400 V/50 Hz

• three models are available:
  1 – N-SRS 1 model for a conveyor with a working width of 240 mm
  2 – N-SRS 2 model for a conveyor with a working width of 340 mm
  3 – N-SRS 3 model for a conveyor with a working width of 440 mm
• this separator is designed for installation on N-CPR and N-CPTR conveyors
• the transfer of motion from the conveyor to the single separator roller is carried out by means of a Pu belt
• thanks to the elasticity of the belt, the distance between the separator roller and the conveyor can be adjusted from a minimum of 5 mm to a maximum of 20 mm
• the conveyor on which the N-SRS separator is installed must have a belt with slats with a maximum height of 20 mm

N-SRS separator with N-CPR conveyor

• three models of N-FSRV separators are available:
  1 – N-FSRV 1 model for a conveyor with a working width of 240 mm
  2 – N-FSRV 2 model for a conveyor with a working width of 340 mm
  3 – N-FSRV 3 model for a conveyor with a working width of 440 mm
• the N-FSRV sprue separator is installed directly on the conveyor, from which the spiral obtains a rotary motion
• the transfer of motion from the conveyor to the spiral roller is accomplished via a PU belt. For safety reasons, the belt is sufficiently tensioned to allow rotation. If the slightest obstacle occurs, the spiral roller stops.

N-FSRV with N-CPR conveyor